SATA 53121 Manual Del Uso página 12

Supplementary Safety Rules for Electric Rotary Hammer:
1 ） Wear a safety helmet and wear earmuffs during operation. Exposure to noise can cause hearing damage.
2 ） Use the auxiliary handle provided with the tool. Handling a hand can cause personal injury, and you should hold the tool with
both hands during operation.
3 ） When the cutting attachment may touch the dark line or its own cord, hold the tool through the insulating grip surface.
A cutting attachment that hits a live wire can electrify the exposed metal parts of the tool and cause an electric shock to the
operator.
4 ） Use a suitable detector to find the location of the hidden power cord. Or ask the local power supply unit for relevant
information.Drilling through wires can cause fire and electric shock. Damage to the gas tube can cause an explosion. Piercing a
water pipe can result in property damage.
5 ） Check that the drill bit has been tightened in the correct position before operation.
6） Under normal working conditions, the tool generates vibration according to the design. Therefore, the screw is easily loosened,
causing damage or an accident.Carefully check the tightness of the screws before handling.
7 ） In cold weather, or for a long time without using it, the tool should be idle for a few minutes to make it warm under no load.This
will make the lubrication smooth, and it will be difficult to use the electric hammer without proper warming up.
8） Make sure you have a stable footing and make sure you are standing still.Seat belts should be worn when you use the tool at a
height, and there must be no other people below.
9） The hand is about to leave the rotating part.
10） Don't let it continue to rotate when you drop the tool. It can only be operated when held by hand.
11 ） Do not let the tool continue to rotate while operating. It can only be operated when held by hand.
12） Do not touch the drill or the parts around the drill immediately after the end of work. These parts can be hot and can burn your
skin.
Instructions for use:
Note:
Before you adjust or check the function of the tool, make sure to turn off the tool and plug out power supply
Note:
Before plugging in the power plug, be sure to check if the trigger switch can be pulled freely and return to the "OFF" position
after release
The tool can be activated by pulling the trigger switch. The greater the force applied to the trigger switch, the faster the tool
speed.Release the trigger switch to stop the tool. When continuous operation is required, pull the trigger switch and press the
lock button. To stop the locked tool, pull the trigger switch to the end and release it.
12
53121/05153
中文
EN DE RU KO
Trigger switch
Lock button
PT JA ES