Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
DETAILED COMPONENTS
1. Mono-block fireplace with guillotine opening
2. Deflexed panel
3. 2 pieces framework for panel support
4. Pot with aerosol painting for final finish
5. Bag with 4 screws to level the apparatus
6. Exothermic glove
7. Tool to manage registers, grill and ash box
8. Envelope containing user's guide: characteristics, assembly, operating and guarantee
9. Ash box
10. Fire grate
11. 8 air outlet adaptors
13. Indoor Heat-resistant panels
Included a rectangular piece that control the load
TECHNICAL CHARACTERISTICS
Parameter
Maximum smokestack intake
Fire type
Fuel consumption
Mass smoke intake
Nominal efficiency
Output
Average temperature of fumes directly into the smoke outlet
CO concentration at an average of 13% O2
Fuel load (test)
Period time to test
Average smokestack intake (test)
Net Weight
Maximum fuel load
1. INSTALLATION PROCEDURES
ALL LOCAL REGULATIONS, INCLUDING THE ONES ACCORDING TO THE NATIONAL OR
EUROPEAN NORMS MUST BE ACCOMPLISHED WHEN PROCEEDING TO INSTALL THE
FIREPLACE.
1.1. Mono-block fire. It is a fireplace with stainless steel panels which has a deflexed panel,
dissembled smoke connection and 2 framework pieces with four sides, evolving convector
outdoor chamber and eight smoke outlets at the top part.
1.2. Freight
. In order to facilitate its mobility and installation, two rings on the upper part
(1-2)
have been provided in case of crane-pick up transportation.
1.3. Fireplace disassembly
be disassembled into two parts: kit guillotine door and fire case. To do so, remove both screws
from the protection and take it off.
Then, remove M6X20 screws (11 in total). In the first place the 9 which fix the door onto the
central panel (fireplace)
Once the screws have been removed, both panels will be freed and can be separated (7).
Repeat the same with the other lateral panel.
Warning: when putting both pieces together again, take into account that the connection
must be perfectly placed.
1.4. Blockage off and door check
mechanism of guillotine opening so it works properly. In some occasions, due to freight, some
failures can be caused: collocation, incorrect level, dilatations, counterweight onto the door so it
gets unlevelled etc. To balance it again, remove front framework, and add or subtract weight (3
mm plates). Once the door is rebalanced, put the panel back and the door will work properly.
Repeat with the second door again.
In order to facilitate its moving to the house, if necessary, it can
(3).
and the 2 rest which stick this part with the sides
(4-5)
Remove door screws. Once the blockage is off, check
(8).
Value
11-13 Pa
On and Off
3,6 Kg/h
14,7 g/s
70,1%
12 Kw
369ºC
0,34%
2,9 Kg
48 min
11,6 Pa
376 Kg
5 Kg
(6).
Página 14 de 19
Publicidad
