CAMPAGNOLO ZONDA Manual Del Usuario página 34

9S, 10S, 11S SPROCKETS FROM SHIMANO INC. and SPROCKETS FROM SRAM CORPORATION (on the Campagnolo
4.3 -
freewheel body for Shimano Inc. 9/10/11s sprockets and Sram sprockets)
4.3.1 - ASSEMBLY
• SHIMANO INC. SPROCKETS
1) Fit the sprockets on the freewheel body and check that:
- the surface with the name of the group of each sprocket is turned
to the outside of the freewheel body.
- the broadest groove of the sprocket (A – Fig. 32) and the broadest
of the freewheel body (B – Fig. 32) are aligned.
Important!
With the 11s freewheel body, only use the adapter (M - Fig.33)
for 9s and 10s sprocket packs by Shimano Inc. and Sram Co. (the
adapter must not be used for 11s sprocket packs by Shimano
Inc.).
The adapter (M - Fig.33) must be fitted on the freewheel body of the
9s or 10s sprocket pack, or on any washer supplied together with the
9s or 10s sprocket pack.
See the instruction sheet provided by the sprocket pack manufacturer
for installation, removal and maintenance instructions.
2) Using tool TL-LR15 from Shimano Inc. or FR-5 from Park Tool Co.
(B - Fig. 34) tighten the lockring (G - Fig. 34) on the freewheel body
to 30-50 Nm (266-443 in.lbs).
• SRAM CORPORATION SPROCKETS
1) The sprockets are preassembled on a support (A - Fig. 35).
2) Insert the support on the side of the freewheel body, align the
grooves, press the sprockets onto the freewheel body and extract the
support (A) from the hub (Fig. 35).
3) Using tool TL-LR15 from Shimano Inc. or FR-5 from Park Tool Co.
(B - Fig. 34) tighten the lockring (G - Fig. 34) on the freewheel body
to 30-50 Nm (266-443 in.lbs).
B
B
32
D
D
30-50 Nm
(266-443 in.lbs)
B
B
CLOSE
34
A
A
33
C
G
B
A
35
®
M
15