Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Upon arrival, check the integri-
ty of the appliance and its com-
ponents (e.g. power cord), pri-
or to use. In the presence of faults
do not start the appliance and con-
tact the nearest service centre.
Read the instructions before
acting.
tions to be performed. As far as per-
sonal
protective
concerned, the European Commu-
nity has issued Directives which the
operators must comply with. Noise
≤ 70 dB.
It is forbidden the installa-
tion of stand alone equip-
ment WITHOUT anti-tip kit
(ACCESSORY). TOP versions
excluded.
For stand alone installa-
tion of the cooking equip-
ment, it is mandatory to as-
semble the supplied anti-tip kit
Before
making
nections check the technical
data shown on the rating plate
of the appliance and the technical
data in this manual. It is strictly for-
bidden to tamper with or remove
the plates and pictograms ap-
plied to the equipment.
Disconnect all supplies, if
present (e.g. water - gas -
electrical) upstream the appli-
ance whenever you need to work in
safe conditions.
Connect the appliance if pre-
sent, in the sequence of the
water, then to the gas network. En-
sure there are no leaks then proce-
ed with the connections to the
mains.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear
protective
equipment suita-
ble for the opera-
equipment
the
con-
- 5 -
The appliance is not designed
to work in an explosive atmo-
sphere and as such its instal-
lation and use is categorically prohi-
bited in such environments.
Position the entire structure,
respecting the installation di-
mensions and characteristics
indicated in the specific chapters of
this manual.
The appliance is not intended
for recessed installation. / The
appliance must be used in a
is
well ventilated area. / The appliance
must have free drainage (not hinde-
red or impeded by foreign bodies).
The gas equipment must be
installed beneath an extrac-
tion hood whose system must
have specifications in compliance
with the current regulations in the
country of use.
Once the appliance is con-
nected to the power and drain
sources, it must remain static
(fixed) in the place of use and main-
tenance. Incorrect connection may
cause danger.
Use where appropriate flexi-
ble cable for connection to the
mains electricity supply with
characteristics not inferior to model
H07RN-F. The supply voltage sup-
ported by the cable with the ap-
pliance working must not differ from
the nominal voltage value ± 15%
shown at the bottom of the techni-
cal data table.
The appliance must be includ-
ed
in
ground discharge system.
Drainage of the appliance
must be conveyed into the
grey water discharge network
an
"Equipotential"
2.
EN
Publicidad
Capítulos
Tabla de contenido
