chapter: "Cleaning instructions"
If present, the indicator lights
must be off at the end of the
work cycle.
Check the cleanliness and hygiene of
the appliance. See "Maintenance".
OBLIGATIONS - PROHIBITIONS -
ADVICE
Before proceeding with the ope-
rations, see chapters 2 and 5
If the appliance is connected to a
flue, the exhaust pipe must be
cleaned according to that forese-
en by specific regulatory provisions of
the country (contact your installer for
information).
The appliance is used to prepare
food products. Keep the applian-
ce and the surrounding area con-
stantly clean. Failure to keep the ap-
pliance in ideal hygienic conditions
could cause it to deteriorate quickly and
create dangerous situations.
Filth deposit built up near heat
sources can burn during normal
use of the appliance and create
dangerous situations. The appliance
must be cleaned regularly and every in-
crustation or food deposit removed.
The chemical effect of salt and/or
vinegar or other acid substances
can in the long run cause the insi-
de of the hob to corrode during cooking.
At the end of the cooking cycle of such
substances, the appliance must be
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
Close the network locks upstream the
appliance (Gas - Water - Electric).
Make sure that the drain cocks (if pre-
sent) are "Closed".
washed thoroughly with detergent,
abundantly rinsed and carefully dried.
Be careful not to damage stain-
less steel surfaces. No not use
corrosive products, abrasive material
or sharp tools.
The liquid detergent for cleaning
the hob must have certain che-
mical features: pH greater than 12,
without chlorides/ammonia, viscosity
and density similar to water. Use
non-aggressive products for cleaning
the inside and outside of the applian-
ce (use detergents on the market for
cleaning steel, glass and enamel).
Carefully read the indications
carried on the labels of the pro-
ducts used. Wear protective
equipment suitable for the operations
to be performed (see the protective
equipment carried on the package la-
bel).
In the event of prolonged inacti-
vity, besides disconnecting the
supply lines, you must thorou-
ghly clean all the inside and outside
parts of the appliance.
Wait for the temperature of the ap-
pliance and all its parts to cool off,
so that the operator is not burnt.
- 17 -
MAINTENANCE
7.
EN
8.