MBM WGE74 Manual De Uso E Instalación página 27

safety of the appliance and must
therefore be performed by technical
personnel of the manufacturer or by
technicians who are formally autho-
rised by the same. Failure to do so
exempts the manufacturer from any
liability for for any possible resulting
modifications or damage.
Upon arrival, check the integri-
ty of the appliance and its com-
ponents (e.g. power cord), pri-
or to use. In the presence of faults
do not start the appliance and con-
tact the nearest service centre.
Read the instructions before
acting.
tions to be performed. As far as per-
sonal protective
concerned, the European Commu-
nity has issued Directives which the
operators must comply with. Noise
≤ 70 dB.
It is forbidden the installa-
tion of stand alone equip-
ment WITHOUT anti-tip kit
(ACCESSORY).
excluded.
Before making
nections check the technical
data shown on the rating plate
of the appliance and the technical
data in this manual. It is strictly for-
bidden to tamper with or remove
the plates and pictograms applied
to the equipment.
Disconnect all supplies (water
- gas - electrical) upstream the
appliance whenever you need
to work in safe conditions.
Connect the appliance in the
sequence of the water, then to
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear protective
equipment suita-
ble for the opera-
equipment
TOP versions
the con-
- 5 -
the gas network. Ensure there are
no leaks then proceed with the con-
nections to the mains.
The appliance is not designed
to work in an explosive atmo-
sphere and as such its instal-
lation and use is categorically prohi-
bited in such environments.
Position the entire structure,
respecting the installation di-
mensions and characteristics
indicated in the specific chapters of
this manual.
The appliance is not intended
for recessed installation. / The
appliance must be used in a
well ventilated area. / The appliance
must have free drainage (not hinde-
red or impeded by foreign bodies).
The gas equipment must be
is
installed beneath an extrac-
tion hood whose system must
have specifications in compliance
with the current regulations in the
country of use.
Once the appliance is con-
nected to the power and drain
sources, it must remain static
(fixed) in the place of use and main-
tenance. Incorrect connection may
cause danger.
Use where appropriate flexible
cable for connection to the
mains electricity supply with
characteristics not inferior to the
type with insulation model H07RN-F.
The supply voltage supported by the
cable with the appliance working
must not differ from the nominal vol-
tage value ± 15% shown at the bot-
tom of the technical data table.
The appliance must be includ-
ed in an "Equipotential" ground
discharge system.
2.
EN