Power Supply Connections; Electrical Connection - MBM PRQ7 T Serie Manual De Uso E Instalación

Tabla de contenido

Idiomas disponibles

single independent unit. Place a spirit

level on the structure (detail D).

Adjust the levelling feet (detail E) ac-

cording to the indications provided by

the level.

Perfect levelling is achieved by

adjusting level and feet on the wi-

dth and depth of the appliance.

"SERIES" ASSEMBLY / see SECT.

IMAGES - REF. c).

Remove the knobs and unscrew the

screws for the fixing of the panel on

both appliances (detail F).

Flammable walls / The minimum

distance of the appliance from

the side walls must be 10 cm and

from the rear wall must be 20 cm. If it is

lower, insulate the walls close to the ap-

pliance with fireproof and / or insulating

treatments.

Place the equipments in order to make

Before proceeding with the opera-

tions, see "General safety infor-

mation".

These operations must be per-

formed by qualified and author-

ised operators, in accordance

with the laws in force and using the

appropriate materials described.

Generally, the appliance is de-

livered without electric mains

supply cable, without pipes for

connection to the water, drainage

and gas networks.

ELECTRICAL CONNECTION

Electrical connection should be per-

THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.

POSITIONING AND HANDLING

their sides perfectly adhere (detail G).

Carry out the appliance levelling as pre-

viously described (detail E).

To place the equipment adherent each

other perfectly (part G). Level the

equipment as described above (detail

E). Remove the protective caps (part

H2). Insert the screws in their housings

and lock the two structures with the

locking nuts (part H1-H3). Replace the

protective caps between the devices

(part H2). Repeat, if necessary, the se-

quence of leveling and fixing operations

for the remaining equipment.

INTRODUCTION

(OPTIONAL)) see SECT. IMAGES

- REF. c) / In order to introduce the

terminal, position it and fix it with the

equipped screws provided (detail L1).

Once the described operations have

been carried out, position again the pa-

nels and knobs of the different applian-

ces in the respective housings.