Kohler STERLING 7612 Serie Guia De Instalacion página 5

1. Construct the Framing
Construct the Floor
IMPORTANT! Construct the floor of plywood. If the whirlpool is installed over material other than
plywood, friction may cause squeaking over time.
If the subfloor is constructed of a material other than plywood, position the supplied felt pad so all
supports will rest on it.
NOTE: The "Roughing-In" section identifies the location of the drain.
Cut a hole in the floor large enough to fit the drain assembly selected for your installation.
Install the Framing
IMPORTANT! Dimensions given in the roughing-in information are critical for proper installation. Refer
to the "Roughing-In" section for dimensions.
IMPORTANT! For installations with wall surrounds, provide support for the vertical wall flanges at
33-1/4" (845 mm).
IMPORTANT! The framing for each stud should be plumb and square to within 1/8" (3 mm). Shimming
may be required.
Carefully measure the whirlpool.
Construct 2x4 framing using the dimensions specified in the "Roughing-In" section.
Construct an access panel to allow access for servicing the faucets and drain.
IMPORTANT! For installations with wall surrounds, do not allow fiber or other soft insulation to drop
down into the back channel, as this could damage the whirlpool.
For installations with wall surrounds, cover or seal any loose material.
Sterling 5 1032207-2-H