Installation Instructions; Product Information - Kohler STERLING 7612 Serie Guia De Instalacion

Installation Instructions

WARNING: When using electrical products, basic precautions should always be followed,
including the following:
DANGER: Risk of electric shock. To reduce the risk of electric shock, connect the pump or blower
only to a properly installed Ground-Fault Circuit-Interrupter (GFCI)*. Do not remove the plug
grounding pin. Do not use a grounding adapter.
WARNING: Risk of electric shock. A qualified electrician should make all electrical connections.
WARNING: Risk of electric shock. Disconnect power before servicing.
NOTICE: Follow all local plumbing and electrical codes. In Canada, install this unit in accordance with
the Canadian Electrical Code, Part 1.
Building materials and wiring should be routed away from the pump body and other heat-producing
components of the unit.
Grounding is required. The unit should be installed by a qualified service representative, and grounded.
Install to permit access for servicing.
A pressure wire connector marked "Earth/Ground" is provided within the wiring compartment. To reduce
the risk of electric shock, connect this connector to the grounding terminal of your electric service or supply
panel with copper wire equivalent in size to the circuit conductor supplying this equipment.
*Outside North America, this device may be known as a Residual Current Device (RCD).

Product Information

Electrical Requirements
NOTE: If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or
similarly qualified persons to avoid a hazard.
The installation must include a Class A Ground-Fault Circuit-Interrupter (GFCI). The GFCI protects against
line-to-ground shock hazard. Use a 120 V, 15 A, 60 Hz dedicated service for the whirlpool.
Product Notices
WARNING: Unauthorized modification of the pump or blower may cause unsafe operation and
poor performance of the product. Do not relocate the pump or blower, or make other modifications
to the system, as this could adversely affect the performance and safe operation of the product.
Sterling shall not be liable under its warranty or otherwise for personal injury or damage caused by
any such unauthorized modification.
Factory-Assembled Features
Factory installed components include: pump with power supply cord, air switch transmitter, and whirlpool
jets with suction fitting.
Connections and Service Access
Before installation, verify proper access to the final connections.
1032207-2-H 2 Sterling