Safety Procedures And Notes Before Switching The Machine On; Routine Inspection - Skymsen FCZ-N Manual De Instrucciones

Avoid mechanical shocks, once they may cause damages or bad functioning.
Avoid water and dust entrance on the mechanical e electrical components of the machine.
Do not change the standard characteristics of the machine.
DO NOT remove, tear off or maculate any labels stuck on the machine. If any labels have
been removed or are no longer legible, contact your nearest dealer for replacement.

4.2 Safety Procedures and Notes before Switching the Machine ON

IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to well understand all the information contained in this manual. If you
have any question contact your supervisor or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation might cause
electrical shocks as well as electrical leak. Before use, check the conditions of all wires and
cables.
4.2.2 Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood. Every
function and operational procedure has to be thoroughly clear to the operator.
Any manual command (switch, button or lever) shall be given only after being sure it is the
correct one.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the machine.
Cables touching the floor or close to the machine need to be protected against short
circuits.

4.3 Routine Inspection

4.3.1 Advice
When checking the tension of the belts or chains, DO NOT introduce your fingers between
the belts and the pulleys and nor between the chain and the gears.
12