Cleaning And Sanitizing - Skymsen FCZ-N Manual De Instrucciones

3.4 Cleaning and Sanitizing

IMPORTANT
Make sure the Temperature Thermostat is on position zero, and then unplug the
machine. Make sure the oil is totally cold.
The equipment shall be cleaned and sanitized when:
- Before to operate it the first time;
- After each working day a partial cleaning shall be made;
- After five operation days a total cleaning and sanitizing operation shall be made;
- Before to operate after a long inactivity period.
1 - Every day cleaning;
At the end of a day of operation a partial cleaning shall be made. Firstly place the
temperature thermostat on position zero, unplug the equipment and let the oil cool
down, clean with a damp cloth the exposed parts of the equipment, then let flow out the
residuals opening the cleaning valve (# 09/Pic.01 and Picture 02) to eliminate any residual
from the tank bottom.
The baskets must be cleaned with water and neutral soap.
At the end of cleaning salt water shall be added up to its level mark.
2 - Every five days cleaning;
Firstly place the temperature thermostat on position zero, unplug the equipment and then
let the oil cool down. To remove the OIL open the valve # 09 (Pic.01) and let them flow out
until the tank # 02 (Pic.01) is completely empty.
After, wash the Tank inside with water and neutral soap, rinse and dry it. Wash the
remaining equipment parts and the basket with water and neutral soap.
3 - In between cleaning;
If it happens that the salt water has to many residues before the end of the five days of
operation period, it may be useful to remove all the salt water. In such a situation clean oil
may be recovered. To do the recovery let the valve open until all the salt water flows out
and shut the valve. Place a bowl below the valve and recover the oil.
Then fill up the tank with the recovered oil making sure the oil level is reached.
IMPORTANT
Never spray water directly on the equipment.
9