ims PRO PULSFEED 4W Manual Del Usuario página 28

POWER SUPPLY - POWER UP
The PULSFEED 4W wire feeder has been designed to work exclusively with the PULSEMIG 400 G (ref. 062665) and 500 G (ref. 062672) generator.
The connection between these two elements is done via one of the following connection cables :
Cooling Length
5m
10m
Air
15m
20m
1.8 m
5m
Water 10m
15m
20m
HUMAN-MACHINE INTERFACE (HMI)
2
ASSEMBLY AND ADVICE
Make sure the welding generator is switched off when connecting or disconnecting the wire feeder.
Connection of the cable to the wire feeder :
- Open the trapdoor to access the interconnect cable connections.
- Pass the interconnection cable through the circular opening at the back of the wire feeder.
- Lock the interconnection cable on the wire feeder by twisting it clockwise by 1/4 then lock the support using the screw supplied with the connection
cable.
- Perform the connection.
Connection on the welding machine side :
- Connect the earth clamp on the positive (+) or negative (-) terminal depending on the type of wire used.
- Connect the interconnection cable on the remaining terminal for power.
- Connect the harness control plug to the 10-pin socket at the back of the generator.
REEL INSTALLATION AND WIRE LOADING (III)
• Remove the nozzle (III-F) and the contact tube (III-E) from the torch.
• Open the machine door.
III-A :
• Position the reel on its support:
- Take into account the drive pin of the reel holder To fit a 200 mm (10kg) wire reel, tighten the wire reel support to the maximum.
• Adjust the brake (III-2) to prevent the wire from tangling when the weld stops. Overall, do not excessively tighten the brake, which would cause
the motor to overheat.
III-B :
• Fit the motor drive rolls suitable for the application. The original drive rolls supplied are double steel groove rollers (1.0 and 1.2).
- Check the marking on the drive roll to ensure that they are suitable for the diameter of the wire
and the material of the wire (for a Ø 1.2 wire, use the Ø 1.2 groove).
- Use drive rolls with V-groove for steel and other hard wires.
- Use drive rolls with U-slots for aluminium and other soft alloy wires.
28
Section Part number
70 mm² 047587
70 mm² 047594
95 mm² 047600
038349
95 mm²
038431
70 mm² 037243
70 mm² 047617
70 mm² 047624
95 mm² 047631
038448
95 mm²
038455
1
3
: visible inscription on the drive roll (example: 1.2 VT)
: groove to be used
PULSFEED 4W
1- Access buttons to the various menus and parameters
2- Adjustment wheel left screen
3- Right screen adjustment knob
EN