Publicidad
Idiomas disponibles
Idiomas disponibles
ISO DIN radio provision with pocket
1. Attach the factory climate controls
to the new radio trim panel using
the factory hardware.
2. Slide the (2) provided speed clips
onto the lower factory mounting
brackets. (Figure A)
3. Attach the pocket to the brackets
using the (4) supplied #8 x 3/8"
Phillips screws. (Figure B)
4. Remove the metal "DIN" sleeve
and trim ring from the
aftermarket radio.
5. Slide the radio into the
pocket/bracket assembly and
secure using screws supplied
with the radio. (Figure C)
99-8907HG
Kit Assembly
(Figure A)
(Figure B)
6. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
7. Mount the radio into the dash
cavity using the factory 10 mm
bolts on the top mounts and
(2) supplied #10 x 3/4" Phillips
screws on the lower mounting
points where the speed clips were
previously attached.
8. Snap the radio trim panel over the
radio and reassemble the dash in
reverse order of disassembly.
6
(Figure C)
Publicidad
