Bosch Mastertech II VCI Instrucciones De Manejo página 13

5.4.2 Enabling point-to-point wireless
communication
The Mastertech II VCI can be configured for
point-to-point wireless communication. The
following illustration shows a single diag-
nostic device connected to a computer us-
ing point-to-point wireless communication.
If you need to reconfigure point-to-point on
your Mastertech II VCI, use the following
procedure.
The steps presented below assume you are
running the Windows 7 operating system on
your computer. The steps may differ de-
pending on the operating system.
1. Plug the WLAN USB adapter into an avail-
able USB port on your computer.
!
Do not plug the wireless adapter into a
USB hub.
2. Switch on your computer.
3. Connect the Mastertech II VCI to your
computer via the USB connecting cable
and allow the Mastertech II VCI to boot
completely.
!
Do not plug the Mastertech II VCI USB
connecting cable into a USB hub.
4. Start the "VCI Manager" program.
i
The point-to-point connection is auto-
matically configured. Wireless commu-
nication will be available when you are
powered through the DLC cable.
If you need to reset your point-to-point
passphrase, follow these steps.
1. Click the wireless network icon in your
Windows taskbar.
Bosch Automotive Service Solutions, Inc.
Mastertech II VCI |
ΠA list of the available wireless net-
works in range of your computer is
displayed.
2. Choose "Open Network and Sharing
Center".
3. Choose "Manage Wireless Networks"
from the left column.
4. Choose "Change adapter" menu and
choose VCI from the list.
5. Remove your stored point-to-point
network. The name will contain
MTS6531 and the last 8 digits of your
Mastertech II VCI's serial number,
(MTS6531xxxxxxxx).
6. When you reconnect the
Mastertech II VCI to the computer using
the USB connecting cable, a new pass-
phrase will be established.
5.4.3 Setting to factory default
Setting the Mastertech II VCI to factory
default restores the point-to-point commu-
nication settings to the setting when it left
the factory. Any software upgrades that
have been installed to Mastertech II VCI are
still installed. When the reset is finished,
the VCI Manager software displays the "VCI
Explorer" tab. All wireless access point
configurations will be lost.
1. Start the "VCI Manager" program.
2. Plug the Mastertech II VCI into an exter-
nal 12V power source.
3. Plug the USB connecting cable into the
computer and Mastertech II VCI and
allow the Mastertech II VCI to boot
completely.
4. Connect to your Mastertech II VCI in the
VCI Manager software.
5. Select the "Network Setup" tab.
6. Click <Set Factory Default>.
"
Mastertech II VCI is set to factory default.
2020.03.02 | 1699200881
13 | en