Connecting The Diagnostic Device To A Vehicle - Bosch Mastertech II VCI Instrucciones De Manejo

en | 14 | Mastertech II VCI
5.5 Connecting the diagnostic
device to a vehicle
Mastertech II VCI kit contains a diag-
nostic connection cable that connects
Mastertech II VCI to the vehicle's SAE J1962
data link connector (DLC).
Refer to the electrical wiring diagram for
the vehicle you are testing to determine the
location of the DLC on the vehicle.
1. Connect the 26-pin end of the diag-
nostic connection cable to the top of
the Mastertech II VCI, and tighten the
screws.
2. Connect the 16-pin end of the diagnostic
connection cable to the vehicle DLC.
Powering the diagnostic device
Mastertech II VCI is powered by the vehi-
cle's 12V or 24V battery.
CAUTION – Non-approved
Accessories - Malfunction
Possible risk of personal
injury
e
Non-Bosch cables are not
approved for use with this
equipment, including a
non-Bosch USB connecting
cable.
1699200881 | 2020.03.02
CAUTION – Cables - Overload
Possible risk of personal
injury
e
Make sure that any cable
connected to a high current
capable power source, such
as a 12V automotive battery,
is in good condition. The
Mastertech II VCI is pro-
tected by its own internal
protection device. A fault in
the cable itself, especially
a power to ground short,
is capable of creating a
hazardous situation that can
cause personal injury.
CAUTION – Loopback Self-Test
Adapter - Overload
Possible risk of personal
injury
e
Do not apply power to
Mastertech II VCI through
the self-test adapter barrel
connector unless the circuit
is protected by a fuse, cir-
cuit breaker, or current-limi-
ted power supply. The fuse,
circuit breaker, or current-li-
mited power supply must be
set to no more than 3 amps.
5.6 Resetting the
Mastertech II VCI
1. Disconnect the power supply from the
Mastertech II VCI.
2. Wait at least 20 seconds.
3. Reattach the power supply to the
Mastertech II VCI.
Bosch Automotive Service Solutions, Inc.