Vehicle Led Is Flashing Red - Bosch Mastertech II VCI Instrucciones De Manejo

6. Troubleshooting
This section is intended to help you get
back on track if the Mastertech II VCI
appears to be operating abnormally. If the
error is not eliminated by the indicated rem-
edy, it is necessary to contact Service.
6.1 Mastertech II VCI error LED
lights after power on
Recommendations
1. Power down the Mastertech II VCI
verify that the same problem exists when
you power up again.
2. Connect the Mastertech II VCI
computer using USB and perform the
recovery procedure.
6.2 The Mastertech II VCI fails
to power up
Mastertech II VCI should power up as
soon as external power is applied. If
Mastertech II VCI does not turn on, first
check the cable connections. Try supplying
power to Mastertech II VCI
ent power sources – the vehicle DLC and the
USB connector.
Recommendations
¶
Check that the cables are securely
attached to the Mastertech II VCI
connector pins are clean.
$
While the diagnostic device is con-
nected to the vehicle DLC, try power-
ing from the USB connector.
$
While the diagnostic device is con-
nected to USB, try powering from the
vehicle DLC.
Bosch Automotive Service Solutions, Inc.
6.3
If the
power on Pin 16 of the diagnostic connec-
tion cable,
the user by automatically turning on and
flashing the vehicle LED red. This condition
might be seen if
powered by a 5V USB connection or if the
diagnostic connection cable has accidently
been displaced from the vehicle DLC and is
powered from the backup capacitor. When
Mastertech II VCI
and 16, the vehicle LED will stop flashing red.
Recommendations
to a 1. Ensure that 12V power is applied to Pin
2. Ensure ground on J1962 Pin 5 is good.
6.4
If
tic services for the computer and does not
detect 12V power on Pin 16 of the diag-
nostic connection cable,
from two differ- will inform the user of the loss of power by
beeping.
beep until the backup capacitor is drained.
When
on Pin 16, the speaker will stop beeping.
and the Recommendations
¶
Mastertech II VCI |

"Vehicle LED is flashing red

Mastertech II VCI does not detect 12V
Mastertech II VCI
Mastertech II VCI
detects 12V power on Pin
16 of the diagnostic connection cable.
Mastertech II VCI speaker is
beeping
Mastertech II VCI is performing diagnos-
Mastertech II VCI
Mastertech II VCI
Ensure that 12V power is applied to Pin
16 of the diagnostic connection cable
during diagnostic sessions.
2020.03.02 | 1699200881
15 | en
will inform
is only
Mastertech II VCI
will continue to
detects 12V power