Publicidad
threshold prior to securing into place.
8. Locate a clean accessable mounting location on the vehicle
near the T-Connector's black box within reach of the white wire and
grounding eyelet. Drill a 7/64" hole.
Caution: Take care not to drill through the body or any
exposed surface.
9. Mount the White wire using the ground screw and eyelet provided.
10. Locate the access grommet in the floor of the vehicle (Fig. 3).
Beginning inside the vehicle, route the black wire connected to the
T-Connectors black box through the
grommet to the outside of the vehicle.
Following existing vehicle wiring,
continue routing the Black wire into the
engine compartment to the area near the
vehicle battery.
Caution: When routing, take care
to avoid hot pipes, heat shields, the fuel tank and
any sharp surfaces or moving parts.
11. Remove the vehicle's negative (-) battery cable. If present, remove
the 7.5 amp fuse from the supplied in-line fuse holder assembly.
12. Strip 5/16" of insulation from the end of the Black wire and connect
it to the fuse holder assembly using the butt connector provided.
13. With the fuse removed, connect the 3/8" ring terminal on the end of
the fuse holder to the vehicle's Positive (+) battery terminal.
14. Reconnect the vehicle's Negative (-) battery terminal and insert the
7.5 amp fuse into the fuse holder installed in step 12.
Caution: Do not exceed fuse rating of 7.5 amps.
Warning: Do not attempt to connect the Black power wire to
the vehicle fuse panel or any other accessory wiring. Failure
to connect directly to the vehicle battery could cause vehicle
damage and/or trailer light failure.
15. Test the installation with a test light or properly equipped trailer
Fig. 3
Publicidad
