General Advice; Filling With Fuel - SDMO VX 220/7.5 H-2 Manual De Uso Y Mantenimiento

1.3.2 General advice

On taking delivery of the generating set, check that it is complete and not damaged in any way. A generating set should be handled
gently and brusque movements should be avoided. Ensure that the place where it is to be stored or used is carefully prepared
beforehand.
Before use:
- make sure you know how to stop the generating set in the event of an emergency,
- make sure you completely understand all the controls and operations.
Warning
For reasons of safety, the maintenance intervals must be respected (see Maintenance table). Never carry out repairs or maintenance
procedures without the necessary experience and/or tools.
Never let other people use the generating set without having given them all the necessary instructions beforehand.
Never let children touch the generating set, even when it is not in operation. Do not operate the generating set near animals (as it could
cause them to panic or frighten them).
Never start the engine without an air filter or exhaust.
Never invert the positive and negative terminals on the battery (if fitted) when fitting them as this could cause serious damage to the
electrical equipment.
Never cover the generating set with any type of material while it is in operation or just after it has been turned off. Wait until the motor is
cold.
Never coat the generating set with oil, even to protect it from corrosion; preservative oils are flammable and can be dangerous if
inhaled.
In all cases, respect the local regulations currently in place concerning the use of generating sets.
1.3.3 Safety guidelines to prevent electrocution
Generating sets produce electric current while they are in operation: risk of electrocution.
The generating set must be earthed every time it is used.
Danger
Never touch stripped cables or disconnected connectors. Never handle a generating set with wet hands or feet. Never expose the
equipment to liquid splashes or rainfall, and do not place it on wet ground.
Always make sure the electric cables and connections are in good condition. Do not use equipment in a poor state of repair: there is a
risk of electrocution or damage to the equipment.
If the length of one or more of the cables used is more than 1 metre, use a differential protection device between the generating set
and the appliances. This device must be positioned at a maximum distance of 1 metre from the generating set electrical sockets. Use
flexible, durable cables with rubber sheathing which conform to the IEC 60245-4 standard or equivalent cables. Do not connect the
generating set to other power sources (such as the mains for example).
Exception: if there is provision for a reserve connection to existing electrical networks, this can only be made by a qualified electrician,
and the equipment's operational differences depending on whether the mains supply or the generating set is used must be taken into
account.
Protection against electric shock is provided by circuit breakers specially designed for the generating set: if necessary, replace them
with circuit breakers with identical nominal ratings and specifications.
1.3.4 Safety guidelines to prevent fire
Never operate the generating set in areas containing flammable products (risk of sparks).
Keep all flammable products (petrol, oil, fabric etc.) out of the way when the unit is in operation.
Never cover the generating set with any type of material while it is in operation or just after it has been
Danger
turned off: always wait until the engine cools down.
1.3.5 Safety guidelines for exhaust gases
The carbon monoxide present in the exhaust gas may lead to death by inhalation if the concentration
levels in the atmosphere are too high.
Always use the generating set in a well ventilated area where the gases cannot accumulate.
Danger
For safety reasons and for correct operation of the generating set, correct ventilation is essential (risk of intoxication, engine
overheating and accidents involving, or damage to, the surrounding equipment and property). If it is necessary to operate it inside a
building, the exhaust gases must be evacuated outside and adequate ventilation must be provided so that any people or animals
present are not affected.

1.3.6 Filling with fuel

The fuel is highly flammable and its vapours are combustible.
Filling should be carried out with the engine turned off. Smoking, using a naked flame or producing
sparks are forbidden while the fuel tank is being filled.
Danger
All traces of fuel should be wiped off with a clean cloth.
Storage and handling of petroleum products must be carried out in accordance with the law. Close the fuel tap (if fitted) each time the
tank has been filled. Never top up fuel when the generating set is in operation or hot.
Always place the generating set on a flat, level and horizontal surface to avoid fuel spilling onto the motor. Fill the tank with a funnel
taking care not to spill the fuel, then screw the plug back onto the fuel tank.
1.3.7 Safety guidelines against burns
Never touch the engine or the silencer while the generating set is in operation, or when it has just stopped.
Warning
Hot oil burns; avoid contact with the skin. Before carrying out any operation, check that the system is no longer pressurised. Never start
or run the engine if the oil filler cap is off (oil may splash out).