Handling And Operation; Display Lighting; Filling The Water Tank - Beem Basic Selection Manual De Instrucciones

EN
6. Perform this process twice. Caution! Do not drink this coffee!
7. Clean the device and accessories (see the "Cleaning and Care" chapter).

Handling and Operation

NOTES
• Do not pour milk or other liquids into the water tank. Only ever use water to make
coffee!
• Never overfi ll the permanent fi lter.

Display Lighting

The display lighting goes out 60 seconds after the last button has been pressed, unless the
device is in operation. Press any button you want to switch on the display lighting.
Further actions can only be carried out once the display lighting has been activated.
Time
As soon as the mains plug is plugged into a plug socket, the display lighting turns on and the
time display 12:00 fl ashes. The clock has a 24-hour time format.
1. Set the hours by pressing the button
2. Set the minutes by pressing the button
The time is saved until a new time is set or the device has been disconnected from the
power supply for more than a minute.

Filling the Water Tank

1. Open the water tank lid (11).
2. Pour the quantity of water required for the number of cups you want (maximum 10 cups)
into the water tank (13).
3. Close the water tank lid. It must click audibly into place.
All of the water in the water tank is always used, regardless of the set number of cups or
coffee strength.
Adding Coffee Beans
1. Take off the lid of the coffee bean compartment (1).
Ensure that the water tank (13) is closed so that no coffee beans can fall into the water
tank.
02049_DE-EN-FR-ES-IT_A5_V4.indb 28 02049_DE-EN-FR-ES-IT_A5_V4.indb 28
(22).
(21).
28
24.09.2018 15:51:07 24.09.2018 15:51:07