EN
Cleaning and Care
NOTES
•
Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to
clean the device. These can damage the surface.
1. Clean the permanent fi lter (17) and the fi lter insert (16) after every use with mild deter-
gent and warm water or in the dishwasher.
2. Clean the thermal jug (6) after every use with mild detergent and warm water. It is not
suitable for the dishwasher!
3. If necessary, wipe down the coffee bean compartment (2) and the lid (1) with a damp cloth.
4. Wipe down the housing with a damp cloth. If necessary, use a little mild detergent to
remove more intense soiling.
5. Check the mains cable regularly for any damage.
Cleaning the Grinder Shaft
The grinder shaft (14) can only be cleaned thoroughly if the grinder shaft between the coffee
bean compartment (2) and fi lter compartment (5) is open. This is only the case during the
grinding process. Immediately after the grinding process, the grinder shaft closes so that no
steam can get into the grinder during the brewing process.
1. Remove the coffee beans from the coffee bean compartment. (Apart from the few beans
that you cannot reach by hand.)
2. Insert the permanent fi lter (17) or a basket fi lter paper into the fi lter insert (16).
3. Use the button
4. Press the button
5. Once the rest of the coffee beans have been ground – you can tell this from the change in
the grinding noise – stop the grinding process by pressing the button
shaft remains open.
6. Open the lid towards the grinder shaft: Press down the locking button (arrow symbol on
the lid) with a pointed object (e. g. pencil, ballpoint pen or something similar) and at the
same time pull the lid off forwards (Picture C1).
7. Clean the grinder shaft on the inside with the cleaning brush supplied (9) (Picture C2).
8. After cleaning, press the locking button and slide the lid back onto the grinder shaft. It must
click audibly into place.
9. Clean the permanent fi lter or dispose of the basket fi lter paper.
02049_DE-EN-FR-ES-IT_A5_V4.indb 34
02049_DE-EN-FR-ES-IT_A5_V4.indb 34
(25) to set the maximum number of cups (10).
(18) to start the grinding process. The grinder shaft opens up.
34
again. The grinder
24.09.2018 15:51:10
24.09.2018 15:51:10