Assembly And Connections - auna Connect Vertical Manual Del Usuario

ASSEMBLY AND CONNECTIONS

1. Place the main unit on a flat level surface.
2. Position the speakers and fully unwind the speaker wires.
3. Connect the right speaker cord to the R speaker socket on the right side
of the main unit
4. Connect the left speaker cord to the L speaker socket on the right side of
the main unit.
5. Fully unwind and extend the DAB/FM antenna wire.
6. Unwind the mains adapter cable to its full length. Connect the end of the
cable to the DC IN socket on right side of the unit and then connect the
mains adapter to the mains socket. Make sure the mains adapter is firmly
inserted into the mains socket. The unit is now ready to use.
7. To switch the unit off completely, unplug the mains adapter from the
mains socket.
Attention: Connecting the unit to any other power source may cause
damage to the unit. -- Hold the power adaptor when plugging it into an
outlet or unplugging it. Never pull or yank on the adaptor cable
Network Connection
This product only supports wireless network connection for network access
and did not support wired LAN
connection
1. Check first of all whether the control lamps (LINK/ACT) of your LAN
connection or your router light up.
2. Proceed for the operation as described in the below "GETTING START".
It is highly recommended to run through the setup wizard in the System
Settings section.
Note: This unit cannot be connected to a standalone modem directly. A
router or a modem incorporated with a router has to be used. Since there
are various connection configurations, please follow the specifications and
instructions of your telecommunication carrier, Internet service provider,
and router setting guidebook.
EN
51