Aux Operation; Headphone Use; Sleep Setting - auna Connect Vertical Manual Del Usuario

EN
72

AUX OPERATION

There is a "LINE IN" socket located at the left side of the unit. Analogue
audio sound signals from other sources can be input to the unit through this
socket.
1. Connect the input to another audio device via an AUX cable (not
included) with "LINE IN" socket.
2. Press MODE repeatedly on the unit or on the remote to select AUX in
mode.
3. Press VOLUME +/- buttons on the unit or press VOL +/- on the remote
control to adjust the volume for your desired sound output level.
4. In AUX mode, operate your audio device directly for playback features.

HEADPHONE USE

Do not listen to music at high volume when using headphones. Doing so
can cause permanent hearing
impairment. Turn the tuner volume level to the lowest before using
headphones.
• Only use headphones with a 3.5-mm jack plug.
• Insert the headphone connector in the headphone socket at the left side
of the unit.

SLEEP SETTING

This function allows you to program the unit to turn to standby mode by
itself after a set period of time.
1. To activate the sleep function, press the SLEEP button on remote control
repeatedly. The time will change in the below sequence on every press::
Sleep OFF > 15MIN > 30MIN > 45MIN > 60MIN
2. When your desired sleep time appears in the display, stop pressing the
button and the sleep function will be activated in two seconds. the moon
symbol will show on the display. Also the time remaining until switch off
is being displayed next to the symbol in the display.
3. When the sleep timer counts down to zero, the unit will turn to standby
mode. To turn the sleep function off while the sleep timer is still counting
down, repeat step (1)-(3) to select "SLEEP OFF". " " will disappear from
the display.
4. Press the SLEEP button once to show the sleep timer status on the
display when it is turned on.