AstroNova QuickLabel QL-850 Guia De Inicio Rapido página 11

11. Tilt the top of the printhead cartridge toward the back of the printer, about 20 degrees. Then
gently place the back of the printhead cartridge into the print engine.
Avoid touching the printhead connector circuit board inside the printer.
12. When the back of the printhead is firmly in place, gently rotate the printhead cartridge
forward into position against the stops on the printhead connector circuit board.
If the printhead will not rotate into position, do not force it. Remove the printhead and
try again.
13. Slowly close the printhead latch. The fluidic couplings should advance and seal to the
printhead cartridge.
If the latch will not close, do not force it. Remove the printhead and try again.
14. Close the top cover.
15. Finish the After Shipping wizard in the QL-850 Maintenance Utility.
QL-850 Quick Start Guide 9