Setting Up Your Multi-Touch Chassis Display; System Requirements; Unpacking Your Touch Display - 3M C3266PW Guia Del Usuario

7
Chapter 1

Setting Up Your Multi-Touch Chassis Display

To setup your display you need to complete the following tasks:
•
Unpack the components
•
Connect the video cable, touch display cables, and power cable
•
Power on the display and test your setup
•
If your operating system does not support native touch, install MT7 software from
the enclosed CD.

System Requirements

This display requires a personal computer (PC).
•
Your PC must have an available USB port or RS-232 serial communication port
(C3266PW only). Connect the touch sensor cable to the communications port.
•
Your PC must have a video card and video driver already installed for the display.
Note: Before setting up your Multi-Touch Chassis Display, refer to the "Important
Safety Information" section at the beginning of this document.

Unpacking Your Touch Display

Carefully unpack the carton and inspect the contents. Your Multi-Touch Chassis Display
includes the following:
USB Cable
VGA Cable
All manuals and user guides at all-guides.com
3M Touch Systems, Inc. Proprietary Information
3M™ Multi-Touch Chassis Display User Guide
9-pin RS-232 serial cable
(Qty 2 for C3266PW only)
DVI Cable