Deactivating The Preset Time; Cleaning And Care - Beem MD-286BT Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

23

Deactivating the Preset Time

To deactivate the preset time, touch the PROG fi eld (17) once. The blue timer control lamp (15)
goes out and the programming is deactivated. However, the preset time is retained and can be
reactivated at any time until a new preset time is programmed in or the device has been discon-
nected from the power supply.

Cleaning and Care

PLEASE NOTE!
Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
the device. These may damage the surface.
1. Empty the permanent fi lter or dispose of the fi lter paper and if necessary empty the thermal
jug (6).
2. Clean the permanent fi lter, the fi lter holder and the thermal jug after every use with a mild
detergent and warm water, or in the dishwasher.
3. Wipe down the inside and outside of the housing with a damp cloth. If necessary, use a little
mild detergent to remove more intense soiling.
4. Check the connecting cable regularly for any damage.
Cleaning the Thermal Jug Thoroughly
Coffee grounds and coffee oil residues can contaminate the thermal jug (6) over time.
It should therefore be thoroughly cleaned regularly (at least every 4 weeks).
We recommend that you do this using BEEM Premium Cleaning Tablets. They will remove the residues
quickly and easily. In addition, the cleaning tablets are gentle on the material and guarantee food-safe
and environmentally friendly cleaning - ensuring an authentic coffee fl avour. BEEM Premium Cleaning
Tablets in a pack of 20 or 50 can be obtained from selected specialist stockists, directly via our web-
site www.beem.de or from our customer service department on request.
Cleaning with the BEEM Premium Cleaning Tablets
1. Dissolve a cleaning tablet in water at 60-70°C.
2. Pour the solution into the thermal jug (6).
3. Move the thermal jug slowly in circular motions to ensure that the inside is wetted with the
cleaning solution.
4. Allow the cleaning solution to take effect for a few minutes.
5. Empty the thermal jug and rinse it thoroughly several times with clear water.
The BEEM Cleaning Tablets do not have a descaling effect!
09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 23
09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 23
EN
26.06.2020 13:27:23
26.06.2020 13:27:23

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido