Harbor Breeze E-ER56ORB3LKLR Manual Del Usuario página 10

FAN MOUNTING
6. Slide yoke cover (D) onto downrod (A) followed
by wire cage (V), canopy cover (I) and canopy
(B). [Note: Canopy cover (I) must be turned with
the shiny side toward the motor housing (E).]
(Fig. 6)
7. Locate hanging ball (K) and stop pin (DD). Check
inside of hanging ball (K) with finger to be sure
surface is smooth; if it is not, partially loosen set
screw on side of hanging ball (K).
Thread wires from top of downrod (A) through
hanging ball (K) and then slide hanging ball (K)
onto downrod (A)--hanging ball (K) must be turned
with the rounded part facing the motor housing
(E). Slide stop pin (DD) through holes at top of
downrod (A), centering the stop pin (DD) in the
downrod (K) so equal amounts show on each side
of the downrod (A). Make sure all three wires
remain on the same side of the stop pin (DD). (Fig.
7A)
Locate slots inside hanging ball (K), turn hanging
ball (K) so slots align with stop pin (DD) and raise
hanging ball (K) to top of downrod (A). [NOTE: It is
extremely important the top of the hanging ball
(K) is flush with the top of the downrod (A); the
stop pin (DD) must sit COMPLETELY inside of the
slot in the hanging ball (K).] Securely tighten set
screw at top of downrod (A). (Fig. 7B)
Hardware Used
Stop Pin
DD
6
B
7A
DD
K
B
7B
DD
Slot
x1
Set Screw
10
I
D
E
Set Screw
Set
Screw
K
K
A
A
V
A
DD
A