Important; Fan Mounting - Harbor Breeze E-ER56ORB3LKLR Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INITIAL INSTALLATION
4.
Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers provided
with the outlet box. (Fig. 4)
*NOTE: It is very important that you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT: If using the angle mount, make sure
open end of mounting bracket (C) is installed
facing the higher point of the ceiling.

FAN MOUNTING

1.
Remove pin (L) and clip (M) from motor housing
yoke at top of motor housing (E) and partially
loosen set screws. (Fig. 1)
*Helpful Hint: Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer
downrod (not included) than the one provided.
Angle style mounting is best suited for angled or
vaulted ceilings. A longer downrod is sometimes
necessary to ensure proper blade clearance.
2. Thread wires from motor housing (E) through
downrod (A). Slip downrod (A) into housing
yoke, align holes and re-install pin (L) and clip
(M). Tighten downrod (A) set screws and then
tighten nuts. (Fig. 2)
4
1
M
E
2
M
E
8
C
Set
Screw
L
A
Set
Screw
L

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

0219421

Tabla de contenido