Harbor Breeze E-ER56ORB3LKLR Manual Del Usuario página 9

FAN MOUNTING
3.
Depending on the length of downrod (A) you
use, you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested that you do so in the
following manner:
Take the lead wires and make sure that you
have pulled them all the way through the top of
the downrod (A). Start at the TOP of the
downrod (A) and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included). (Fig. 3)
NOTE: If you do not cut back the lead wires,
Steps 3 and 4 are not necessary and you may
proceed to Step 5 instead.
4.
If you decided to cut back the lead wires in
Step 3, strip 1/2 in. of insulation from end of
white wire. (Fig. 4) Twist stripped ends of each
strand of wire within the insulation with pliers
(not included). Repeat Step 4 for black, blue (if
applicable) and green wires.
5. Set the reverse switch--located on the top of the
motor housing (E)--to the LEFT position for a
downward airflow to create a wind chill effect or
to the RIGHT position to create an upward
airflow that will help move hot air off the ceiling.
You will need to listen for a CLICK to be sure
the switch has been moved completely to the
left or completely to the right. (Fig. 5)
IMPORTANT: If you do not hear a click, the
switch is not set properly and the fan will not
function.
For further information on the reverse switch,
please see Step 2 on pages 18 and 19 in
"Operation Instructions for Remote Control and
Fan".
3
4
5
E
9
A
Reverse
Switch