Harbor Breeze E-ER56ORB3LKLR Manual Del Usuario página 12

WIRING
1. Make the necessary wiring connections for remote
control operation according to Fig. 1. For each wire
connection, use one of the wire connectors (CC)
provided, making sure to screw wire connector
(CC) on in a clockwise direction. [Make sure to
connect all GROUND (GREEN) wires together from
fan (on hanging ball (K) and mounting bracket (C))
to BARE/GREEN wire from ceiling.]
WIRING TIP: Wiring your fan's remote control
requires extreme patience. Take mandatory breaks
while wiring to allow your arms to rest.
Wrap electrical tape (not included) around each
2.
individual wire connector (CC) down to the wire as
shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of
box from the black connections.
Hardware Used
E3 Wire Connector
CC
3.
Gently slide remote control receiver (S), smooth
side up, into mounting bracket (C). (Fig. 3) Turn
spliced/taped wires upward and gently push wires
and wire connectors (CC) into outlet box. Let
antenna from remote control receiver (S) hang to
the side.
Note: The remote control included with this fan
meets the following requirements:
a. Not for use with solid state fans.
b. Electrical rating: 120V / 60 Hz; motor
amps:1.5 MAX.;
light watts: 300 (Incandescent only).
Should you choose to use a different remote control
with this fan, it must also meet these same
requirements.
1
120 V Power
FROM CEILING
BLACK
WHITE
WHITE
BLACK
BLACK
WHITE
AC SUPPLY
2
CC
x4
3
Antenna
12
S
ANTENNA
BLUE BLUE
BLACK
WHITE
BARE GREEN
S
C
A
K
CC
CC
C
A