Automated Learning Process/Activating Code - Harbor Breeze E-ER56ORB3LKLR Manual Del Usuario

FINAL INSTALLATION
7.
Align openings in grooves of glass shade (O)
with small protrusions on the inside of the shade
fitter (P). Turn glass shade (O) to the right
(clockwise) until it no longer turns. (Fig. 7)
Make sure that glass shade (O) is turned
completely to the right so that it is securely
attached.

AUTOMATED LEARNING PROCESS/ACTIVATING CODE

CAUTION: The remote control transmitter (Q)
can be programmed to multiple receivers or fans.
If this is not desired, turn wall switch off to any
other programmable receiver or fan.
1. Remove battery cover from back side of remote
control transmitter (Q).
Locate dimmer switch located
code switches--dimmer switch is labeled with a
"D" and an "X". Dimmer switch is pre-set to the
"ON" [D] position. If you do not wish to have
dimming capability, you may set the dimmer
switch in the "OFF" [X] position. (Fig. 1)
Install the 12-volt battery (R) provided, and then
replace battery cover on remote control
transmitter (Q). (Fig. 1)
(Fig. 1)
to the right of the
16
7
P
O
1
Code Switches
Q
(back)
E
Prongs
Grooves
Dimmer
Switch
Battery
Cover
R