Charging - Amibot PURE LASER Manual Del Usuario

Operating the robot

Charging

Assembling the home base
To plug in the home base, open the cover under the robot and plug
in the power cable. Wind the cable around integrated cable tidy
and thread through the recess. Then put the cover back on again.
Place the home base on a level surface next to a wall, at a right angle
to the floor. Keep a distance of at least 1.5m in front of the base and
0.5m at either side.
NOTE: When your AMIBOT Pure Laser robot is on its home base, make sure that
your robot is switched on and the home base power light is on.
Switching the robot on
0.5m
Press the power button for 3
seconds. The robot is ready to
be charged.
11
EN
0.5m
1.5m