Amibot PURE LASER Manual Del Usuario página 34

EN
Troubleshooting
No. Problem
The appliance
01 does not switch
on.
The robot does
02 not charge any
more.
The robot
03 does not move
correctly
Appliance
04
suction lost
Cause
1. The appliance is not
switched on.
2. The appliance
run out of battery.
1. The robot is
correctly positioned
on the home base or
it is not plugged in
correctly.
2. The robot is
switched on.
1. The floor is wet.
2. The dustbin is not
attached correctly.
3. The central
is not inserted
correctly.
1. The dustbin is full
2. The central brush or
the side brushes are
blocked.
32
Solution
1. Switch the robot on.
2. Charge the robot using
has
its home base.
not
1. Correctly reposition
the robot and place its
power sensors on the
home base sensors.
not 2. Switch the robot on.
1. Dry the floor.
2. Remove and reinsert
the dustbin.
brush
3. Remove and reinsert
the brush in its cavity.
1. Empty the dustbin,
clean the motor and
the filters.
2. Remove any hair
and debris from
the brushes. Check
that there is no dirt
obstructing the robot.