Luminance Brands Kathy Ireland Home MIDWAY ECO LED CF955LBS00 El Manual Del Propietario página 9

3. Ceiling Fan Assembly
3.11
To ensure proper Blade Assembly, make sure the
Labels on the Blades are facing the ceiling.
Slide Blade through Center Slot in Fan Housing
(Figure 11).
Mount each Blade to Fan Housing using a #10 Fiber
Washer (supplied) and a #10-24 x 1/2" Slotted Phillips
Washer Head Blade Screw (supplied), 3 per Blade.
NOTE: Be sure to place one fiber washer onto each
screw before installing into the blade.
NOTE: Take care not to scratch fan housing when
installing blades.
A spare #10-24 x 1/2" Slotted Phillips Washer Head
Blade Screw and a spare #10 Fiber Washer are
supplied in the loose parts bag, if required.
3.12
Remove and retain One of the Three #8-32 x .375"
Pan Head Screws in the Motor Assembly and loosen
the remaining Two #8-32 x .375" Pan Head Screws
(Figure 12).
3.13
Orient the Lower Housing correctly to install onto Motor
Assembly, as shown.
Route the Motor Assembly Wires and Terminals
through the Center Hole of the Lower Housing.
Rotate the Lower Housing clockwise to engage the Key
Hole Slots onto the Two loosened #8-32 x .375" Pan
Head Screws. (Figure 13).
Secure the Lower Housing by tightening the Two #8-32
x .375" Pan Head Screws.
Reinstall and tighten the previously removed #8-32
x .375" Pan Head Screw.
A spare #8-32 x .375" Pan Head Screw is supplied in
the loose parts bag, if required.
(Continued)
MOTOR HUB
BLADE SLOT
IN HOUSING
Figure 11
Figure 12
REINSTALL ONE
#8-32 x .375"
PAN HEAD SCREW
LOWER
HOUSING
Figure 13
9
#10-24 x 1/2" SLOTTED
PHILLIPS WASHER HEAD
BLADE SCREW
(3 PER BLADE)
#10 FIBER WASHER
(3 PER BLADE, EACH LOCATED
UNDER EACH SCREW)
FAN BLADE
LABEL
(FACING CEILING)
REMOVE ONE #8-32 x .375"
PAN HEAD SCREW
MOTOR ASSEMBLY
LOOSEN TWO
#8-32 x .375"
PAN HEAD SCREWS
RETIGHTEN TWO
#8-32 x .375"
PAN HEAD SCREWS
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF955L