Installation - COZY W255GPPR Instrucciones De Instalación Y Funcionamiento

STEP 10.
- Remove the door from the heater housing.
- Locate the Pilot Pro in the carton and remove the cover from
baseplate with a screwdriver.
- The Pilot Pro may be installed near the base of either side of the
heater housing. When selecting a side for installation, be sure to
allow room for future removal of the pilot pro cover.
- Check the inside of the housing for safety labels. Try to avoid drilling
through any pertinent safety information during this step.
USE THE MOUNTING PLATE ( 30 ) FOR THE
FOLLOWING STEPS. MOUNTING PLATE MUST
BE MOUNTED AS DIRECTED BELOW OR WIRE
HARNESS WILL NOT REACH.
1. PLEASE NOTE
Do not mount the PilotPro any higher than the top of the
access door of the housing.
2. PLEASE NOTE
Align the PilotPro very close to the back edge of the housing.
3. PLEASE NOTE
Be sure to face the notch / cutout of the mounting plate (30)
toward the wall.
4. Using the mounting plate (30) as a template, align in place as
illustrated. Using a marker or pencil, leave a mark for the three
hole locations on the metal housing.
SET ASIDE THE MOUNTING PLATE ( 30 ) .
DO NOT DRILL DIRECTLY THROUGH MOUNTING PLATE.
DRILL MAY CRACK THE MOUNTING PLATE.
5. Drill the three holes into housing using a 3/16" drill bit.
A
OF THIS STEP.
B
OF THIS STEP.
Left Right
Side of Side of
Heater Heater
C
OF THIS STEP.

INSTALLATION

Page 11
30
A
B
Install on the right
side OR left side of
the housing.
C
C
30
A
B
1018454-E