STEP 11.
With a phillips-head screwdriver, attach the controls
assembly to the side of the heater using:
- x3 Screws #8-32 x 3/4" (34)
- x3 Nuts #8 (36)
DO NOT use a powered drill
for this step, it could crack the
mounting plate.
USE A SCREWDRIVER AND
HAND-TIGHTEN ONLY.
STEP 12.
To fasten front panel to furnace, be sure exposed portion of
header is free of debris. Place outer panel over furnace with
top of panel about one inch above header and centered in
opening. Keep front panel flush to finished wall and slide down
until rear flange of top outer panel is wedged tight against the
front of the plaster ground channel and flush with wall.
CAUTION: DO NOT HANG FRONT PANEL BEHIND
(OVER FRONT LIP) THE PLASTER GROUND CHANNEL
AS THIS COULD RESULT IN EXCESSIVE NOISE.
Open bottom door of front panel and place sheet metal screw
into locking latch. Secure top of front panel to header plate with
screw provided. This will hold front panel securely to wall.
See Figures 7-B and 7-C (on page 10)
and 8-C (to the right).
NOTE: Leave the access door open until installation is
complete.
INSTALLATION
Page 12
34
34
36
36
FIG. 8-C
Casing
"Z Bracket
Front Panel
Door
MAKE SURE THERE ARE NO
SHARP EDGES ON THE RIM OF THE
HEATER HOUSING THAT COULD
POTENTIALLY DAMAGE THE WIRES.
34
36
Front Panel
1018454-E