Rs Range Extender; Range Extender Assembly; Connecting The Range Extender To Rise; Operation Of The Range Extender - Orbea Rise Manual Tecnico

68 | ORBEA

RS RANGE EXTENDER

The Orbea RS Range Extender connects to Rise to add
252 Wh of extra capacity to the system, bringing the total
capacity, together with the internal battery, to 612 Wh.
Thus, the Range Extender will extend the range of Rise
by 70% when compared to the range achieved with the
internal battery only.
RANGE EXTENDER TECHNICAL SPECIFICATIONS
VOLTAGE
CAPACITY
WEIGHT
CELLS
CHARGING TIME (2A)
ASSEMBLY
CONNECTION

RANGE EXTENDER ASSEMBLY

Install the Range Extender dedicated mount onto the
recommended torque setting of 5 Nm.
When installing the Range Extender holder, remove the
four washers pre-installed on the frame and make sure
that, once installed, the Range Extender´s six contact
points rest correctly against the downtube.
Install the Range Extender into the mount and secure it
with the side o-ring.
The Range Extender bottle holder is compatible with stan-
dard bottles when the Range Extender is not installed.
TECHNICAL MANUAL
36V
252 Wh
1.4 Kg
LITHIUM-ION. 18650
3.5 HOURS
DEDICATED BOTTLE HOLDER MOUNT ON DOWNTUBE
RANGE EXTENDER CONNECTION CABLE TO RISE CHARGING POINT
BLUE PAPER RISE · 2021
CONNECTING THE RANGE EXTENDER
TO RISE
Connect the Range Extender cable to the Range Extender
charging point. Open the charging point cover on Rise and
connect the free end of the Range Extender cable.

OPERATION OF THE RANGE EXTENDER

The Range Extender powers the EP8 RS motor directly.
When using Rise with a Range Extender connected to the
system, the motor will only draw powers from the Range
Extender until the Range Extender is depleted. When there
is no charge left in the Range Extender, the internal battery
will start powering the motor if it had any charge left.
ORBEA | 69
EN
If Rise was On when connecting the Range
Extender to the bicycle, the system will turn
itself Off and you will need to turn Rise On
again pressing the power button.
This happens so the system can reboot and
recognize the Range Extender as part of the
power system when Rise is turned On again.
If you were recording an activity with Garmin
Connect using Orbea RS Toolbox, this will
have no effect on the data recorded in the
activity. The Rise data will keep registering
when you start using Rise again.
Once you turn Rise on, the Range Extender
will be operative. It is not necessary to turn
the Range Extender On.