Pack Side - Program New Temperature And Volume Settings; Flow Side - Program New Temperature And Flow Rate Settings - Dentsply Sirona Calamus Dual A1300 Manual Del Usuario

STEP-BY-STEP INSTRUCTIONS
6.3.3

PACK Side - Program new temperature and volume settings

1. Press the Pack Temperature button on the left side of the keypad
and then use the up / down buttons to set the desired temperature.
Press either button repeatedly to increase / decrease the temperature
in 10°C increments, or hold down the button to rapidly scroll through
the temperature range (100°C minimum to 400°C maximum). The
temperature settings are displayed on the numerical LED Window
and the yellow Pack Temperature LED illuminates, indicating that the
temperature setting mode has been enabled.
Note
The thermal response mode temperature is preset to 90°C and is not
adjustable.
2. Press the Volume button and then use the up/down buttons to set
the desired audible tone volume. Press either button repeatedly to
increase/decrease the volume level in 20% increments, or hold down
a button to rapidly scroll through the volume range (0% minimum to
100% maximum). The volume settings are displayed on the numerical
LED Window and the yellow Volume LED illuminates, indicating that
the volume setting mode has been enabled.
Note
The numerical LED Window automatically defaults to displaying the
selected temperature setting. If the Volume button is pressed, the
numerical LED Window will display the volume for 5 seconds and then
revert to the selected temperature setting.
6.3.4

Flow Side - Program new temperature and flow rate settings

1. Press the Flow Temperature button on the right side of the keypad
and then use the up/down buttons to set the desired temperature. The
LED diode next to the button will flash, indicating that the hand piece is
heating up.
2. Press the Flow Rate Button and use the up/down buttons to set the
desired flow rate.
BENCALDDFUWEB / Rev.04 / 02-2019 (Old ZF 1902103.EN) 13/40