Tekview PowertxtDuo Manual Del Usuario página 6

TECHNICAL INFORMATION
10
Step 4 lift top U-shell directly upwards.
Warning: Do not lift at an angle (to avoid damage to internal light pipes)
now the device is open you can insert your sIM card.
Warning: alWaYs disconnect/isolate mains power and any other connected
devices before inserting / removing a sIM card.
Please note units supplied within the eMea region are 2G and units supplied
within north america, australia and some other regions are 3G. This does not
have any effect on the products capability, the 2G and 3G units have exactly
the same features just slightly different internal components. Powertxt Duo®
has no data capabilities. For north america, australia and other regions 3G
compatible sIMs are required and for the eMea region 2G compatible sIMs
are required. (For the eMea region this product doesn't work with 3G/Data
only sIMs e.g. the Three network)
The sIM is inserted as shown below (inside the yellow circle);
Warning: When placing the Powertxt Duo lid back on please be very careful,
as, if the lid is not placed on correctly this could damage the light pipes or the
internal components. alWaYs make sure the antenna inside is tucked down
towards the bottom of the box so it does not get damaged when putting the
lid back on.
To place the lid back on, place the lid on at an angle putting the end with the
IeCs down first then the end closest to the leD indicators (making sure the
light pipes are not damaged) and clip into place. note – this can be a bit
fiddly however please be patient and the lid will clip back into place. Then
screw the screws back into place.
11