Controlling Devices; Rebooting Devices; Powertxt Duo® Status's; Output & Power Loss Status - Tekview PowertxtDuo Manual Del Usuario

MANAGING POWERTXT DUO® BY SMS
16

3.5. Controlling Devices

Note: When turning any equipment plugged into Device 1 or 2 On/OFF the
leDs will go OFF/On almost immediately.
send the following sMs commands to control the devices:
#Password#10#1#1# Device 1 – Turn On
#Password#10#1#2# Device 1 – Turn OFF
#Password#10#2#1# Device 2 – Turn On
#Password#10#2#2# Device 2 – Turn OFF
#Password#10#3# Device 1 & 2 – Turn On
#Password#10#4# Device 1 & 2 – Turn OFF

3.6. Rebooting Devices

Note: When rebooting Device 1 and/or Device 2 the yellow device leD/s will
turn OFF, an sMs message will be received and approximately 60-90 seconds
later the yellow device leD/s will turn back on and your connected
equipment will have rebooted.
send the following sMs commands to reboot the devices:
#Password#11#1# Device 1 – reboot
#Password#11#2# Device 2 – reboot
#Password#11#3# Device 1 & 2 - reboot
POWERTXT DUO® STATUS'S
4.1. Output & Power Loss Status
an output and power loss status includes the following information;
Device 1 & 2 output On/OFF, last Time Mains Power was lost
To get an output and power loss status send the following command;
#Password#16#

4.2. Network Signal Strength

The network signal strength is a percentage reading (e.g. 28%).
To get the network signal strength please send the following command;
#Password#18#
17