Managing Powertxt Duo® By Sms; Setting The Master Number; Setting The Time/Date; Power Loss/Restore - Tekview PowertxtDuo Manual Del Usuario

MANAGING POWERTXT DUO® BY SMS
14

3.1. Setting the Master Number

The user must send the following sMs (text message) from their mobile
phone (cell phone), they will then become the master user.
(Please choose your password to enter into the command below)
Note: Please MaKe a nOTe OF THe PassWOrD – THIs PrODUCT neeDs THe
PassWOrD TO OPeraTe. Please KeeP THe PassWOrD saFe
#Password#00#
e.g. #1234#00#

3.2. Setting the Time/Date

This will set the time and date automatically from the sIM card network time;
#Password#01#

3.3. Power Loss/Restore

Powertxt Duo® is automatically set up to send power loss/restore
messages/alerts, please see the information below;
3 seconds
If the mains power is lost for 3 seconds or less no power loss message will be
generated
4-10 seconds
If the mains power is lost and then restored in between 4 and 10 seconds
(e.g. before the leDs on the box go out) a power loss message and power
restored message will be generated and received almost immediately
10+ seconds
If mains power is lost for 10+ seconds (e.g. when the leDs on the box have
gone out) a power loss message will be generated and received almost
immediately then when power is restored Powertxt Duo® will take
approximately 60-90 seconds to start up and send the power restored
message

3.4. Additional Users

Powertxt Duo® can have up to 4 additional users that can control the device
but the master user always gets notified of any changes (e.g. if the additional
user turns one or both of the connected devices on/off, or reboots either of
the devices, the master user will be notified of the changes and also which
user requested the changes). The additional users mobile number (cell
number) needs to be added with the county code first e.g. a UK mobile
number would be entered; 447590111222 or a Us number would be entered
12061234567.
note – Only the master user receives the power loss message
You can add one additional user or several using the commands below;
add One additional User
#Password#03#additionalUser#
e.g. #1234#03#447590111222#
add several additional Users in One Command
#Password#03#additionalUser#additionalUser#additionalUser#
e.g. #1234#03#447590111222#447590222333#447590333444#
You can also delete an additional user, delete several additional users or
delete all additional users.
Delete One User
#Password#04#additionalUser#
e.g. #1234#04#447590111222#
Delete several additional Users
#Password#04#additionalUser#additionalUser#additionalUser#
e.g. #1234#04#447590111222#447590222333#447590333444#
Delete all Users
#Password#04#
15