Vorwerk Kobold VB100 Manual De Instrucciones página 70

Setting the brush mode
The electric brush will start in the mode that was last
selected. You can set the operating mode using the foot
switch on the electric brush.
1. Select the correct suction power level for your floor
according to the table on page 23.
2. Press and release the foot switch
brush mode.
The LEDs on the electric brush show which brush
mode you are in.
3. Press and hold the foot switch
2 seconds to deactivate the brush.
The LEDs on the electric brush go out.
4. Press the foot switch
brush.
To find out more about the 'Deactivate brush'
mode, see chapter "6 Troubleshooting" on page 38.
22
to change the
for approximately
again to reactivate the