Installation On Luminance Brands Fans Having Two-Piece Die-Cast Switch Housing - Luminance Brands Kathy Ireland Home LK65 Serie El Manual Del Propietario

5. Installation on Luminance Brands Fans Having
Two-Piece Die-Cast Switch Housing
5.1
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to install the Ceiling Fan Light Fixture .
5.2
Remove the Two Cover Screws from the Switch
Housing Cover below Ceiling Fan (Figure 13) .
5.3
Replace the previously removed Two Screws loosely in
the Switch Housing .
Do not tighten the Screws, as shown in Figure 14 .
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
SWITCH
HOUSING
SWITCH
HOUSING
COVER
SCREWS (2)
Figure 13
SWITCH
HOUSING
REPLACE
SCREWS (2)
Figure 14
10
WARNING
FAN
SPEED
CONTROL
CHAIN
SCREWS (2)
U.L. Model No.: LK65