GYS SPOT LIFT EASY Manual Del Usuario página 17

Translation of the original notice
1/ NO-LOAD START
- Connect the pump to your compressed air system,
- Check that the pressure required for operation is correct (between 5 and 8 bar).
2/ CHECKING THE LIFT
Press the right side of the pump («PUMP») with your foot while positioning your hands on the handles of the SPOT LIFT
EASY. Keep your foot on the pedal until the fork is fully raised.
NB: with no-load, the column may vibrate and make noise when lifting, this is normal.
3/ CHECKING THE LIFT
Press the left side of the pump («RELEASE») with your foot while positioning your hands on the handles of the SPOT LIFT
EASY. Keep your foot on the pedal until the fork is completely down.
NB: with no-load, the fork may jerk down, this is normal.
INSTRUCTIONS FOR USE
Before lifting a vehicle, make sure the handbrake is released and no gears are
engaged. Also check that the vehicle's tyre pressure conforms to the manufacturer's
recommendations.
It is recommended to wear hearing protection when using the Spot Lift Easy.
Never put your hands inside the Spot Lift Easy, there is a risk of crushing.
Never put your hands inside the Spot Lift Easy, there is a risk of pinching.
1/ LIFTING
- Position the jack so that the fork is well positioned on the sides of the wheel. When using the undercarriage lifting
accessory, check that it is correctly positioned.
Press the right side of the pump («PUMP») with your foot while positioning your hands on the handles of the SPOT LIFT
EASY. Keep your foot on the pedal to the desired working height.
- For safety reasons, place jack stand underneath the raised vehicle to support it.
2/ LOWERING
- Remove the jack stand from the underneath of the vehicle.
- Press the left side of the pump («RELEASE») with your foot while positioning your hands on the handles of the SPOT
LIFT EASY. Keep your foot on the pedal until the fork is completely down.
In case of prolonged non-use, lower the SPOT LIFT EASY to the ground. Never leave
the raised vehicle at rest without supervision.
CONTROLS AND MAINTENANCE
Inspections and maintenance work must be carried out by authorised personnel at the maintenance intervals specified in
this manual. In order to guarantee a long service life and proper use of the SPOT LIFT EASY, the following points must
be observed.
• Disconnect the air supply to your SPOT LIFT EASY before performing any maintenance,
• Lower the fork to the low position,
• Only original spare parts must be used «Spare Parts»,
• The recommended maintenance intervals must be respected « Maintenance table «,
• For maintenance work that is not shown or indicated in the operating instructions, contact your distributor and/or
SPOT LIFT EASY
EN
17