Nogueira FTN-1000 G3 Manua De Instrucciones página 196

6. Maintenance
NOTE!
To ensure uniformity, the sharpening
stone should remain spinning during
sharpening. If this is not happening,
you should manually push it as follows:
Turn off the power take off.
1.
Move the sharpening stone away from
2.
the knives.
W i t h y o u r h a n d , t u r n t h e s t o n e
3.
counterclockwise (facing the sharpener).
Turn the machine on and restart
4.
sharpening.
If the knives are very worn, not
allowing adjustment with the counter
knife, replace all (the complete kit).
A replacement of only one knife will
cause unbalance of the rotor.
When it is too worn, the sharpening
stone will not touch the knives, making
it impossible to sharpen. In this case, it
must be replaced by a new one.
Once the knives have been sharpened,
the counter-face must be adjusted
again as described in item 6.7.
CAUTION!
The presence of people or animals near the
outlet chute during sharpening procedure
is prohibited. During the procedure, sparks
may be released from the outlet chute and,
if they strike people and animals, they may
cause injury to the skin and eyes.
84
Instructions Manual