Gun Initialize - NAMCO TIME CRISIS 4 DX Manual Del Operador

6-2-3-2

Gun Initialize

This screen is used to adjust the gun sight.
1. Select 'GUN INITIALIZE' on the I/O Test Menu screen, and press the Enter button,
or slide the Test switch ON ` while pressing the Enter button. The following screen
will be displayed.
PUSH SERVICE SW : ADJUST GUN SIGHT
ENTER SW : EXIT
GUN INITIALIZE screen (1)
2. The Gun Assy's sighting can be checked on the above screen.
When the gun is aimed at the screen, the gunsight (crosshairs) will appear on the
screen.
Ensure that the gun is aimed within the rectangle and that the sight is in the correct
position. (Check all areas of the screen.)
When the gun is aimed outside of the rectangle, the 'OUT OF SCREEN' message
should be displayed at position (a).
If the 'OUT OF SCREEN' message frequently appears even though the gun is
aimed within the rectangle check the following:
• Bright light shining or reflecting on the LEDs around the screen.
• Gun Assy too close to the screen. (less than 60cm)
• The gun is at too great an angle to the screen.
Either move the machine or reduce the lighting and aim with the correct distance and
angle. If the problem still persists or if the gun sight (crosshair) is not displayed in the
correct position, continue with the following:
58
GUN INITIALIZE
+OUT OF SCREEN+
AIM AT SCREEN
TO CHECK GUN ACCURACY
(a)
(Gun Cross)
This indication appears
when the gun is aimed
toward the scren,