Fitting The Header Assembly - NAMCO WANGAN MIDNIGHT Manual Del Operador

5-2

Fitting the Header Assembly

The Header Assembly has a forward centre of gravity, so it is important that at least
two people are used to fit or remove the Header Assembly.
The fitting position of the Header Assembly is very high, and it is important that a
means of reaching the height safely , without stretching, is available (e.g. steps, step
stool etc.)
1. Remove 3off security screw (M5x12) and remove the Header Acrylic
Retaining Bracket.
2. Remove the Header Acrylic.
Security screw (M5 x 12)
Pozi head screw
(with flat/spring washers) (M6 x 16)
Header Assy
3. Place the Header Assembly on to the top of the Monitor Cabinet and connect
the connector.
4. Fit 2off Pozi head screws, with flat and spring washer, (M6x16).
Pozi head screw
(with flat/spring washers) (M6 x 16)
Header Assy
Page 36
Header Acrylic Retaining Bracket
Header Acrylic