Technical Parameters - Baxtran BR95 Manual De Instrucciones

* CALIBRATION OF WEIGHT (SPAN)
Press the key
Press the keys
Pulsar la tecla
Pulsar la tecla
Place the weight of calibration on the platform and press the key

10. TECHNICAL PARAMETERS

DO NOT MODIFY THE TECHNICAL PARAMETERS IF IT IS NOT STRICTLY NEEDED. A BAD CONFIGURATION OF THIS SECTION CAN
CAUSE A WRONG FUNCTIONING OF THE SCALE.
ENTRANCE AND EXIT OF THE CALIBRATION
DISPLAY
LF 1
CALIBRATION OF THE WEIGHT
DISPLAY
LF 1
CAL Z
150.00 kg
150.00 kg
150.00 kg
, the display will show the value of the weight of calibration.
and to move the cursor.
to modify the value of the weight of calibration.
to confirm.
• With the visor switched off, press and hold the key
screen, then you can release the key
• Press the key to start or the key
LF 1
The calibration can be done with any weight, but the weight ca not be inferior to 1/3 of the maximum
capacity and it must also never be exceeded.
•Press the key to start the calibration of zero ( press
to the menu LF1)
•Use , and
calibration will be done. ( press the key
•Place the required weight on the scale as it is indicated in the display.
•Once everything is steady, press the key
and go back to the menu LF1).
THE CALIBRATION IS GOING TO FINISH AND THE SCALE WILL GO VACK TO THE WEIGHING MODE AUTOMATICALLY.
to do the calibration once the reading is stable.
DESCRIPTION AND SEQUENCE OF USE
.
to exit the menu and the indicator will begin again automatically.
DESCRIPTION AND SEQUENCE OF USE
0 ~ 9
, and then press
to exit the calibration and go back to the menu LF1)
to calibrate it ( press the key ESC to exit the calibration
USER'S MANUAL BR95
until the message 100911, appears on the
to exit the calibration and go back
to introduce the weight with which the
EN
39