tau K126MA Guía Para La Instalación página 25

ing of the radio controls.
always on (green):
fast flashing (green):
always on (yellow):
fast flashing (yellow):
always on (red):
fast flashing (red):
flashing (green):
always on (green):
flashing (yellow):
always on (yellow):
flashing (red):
always on (red):
When LEDs DL7 and DL8 flash at the same time they indicate:
flashing + (red + red):
flashing + (yellow + yellow):
Multiple errors are signalled by a 2-second pause between signals.
Should the encoder (obstacle detection) activates while closing, the controller will reverse the direction
and slowly open until the laef reaches its fully opened position. Auto Close function will be deactivated
until a further command pulse is given. In case of 5 consecutive safety interventions the controller will
progressively increase the Auto Close delay. Once the closing has been succesfully achieved, the Auto
Close delay will go back to standard setting.
9. ABSORPTION CHECK FUNCTION (from 5.17 release onwards)
This function allows to monitor the absorption during a complete cycle in order to value the motor stress.
To activate this function press and hold for 2 seconds simultaneously CH1, PROG, CH2 and them start
the motor (OP/CL contact, remote, PROG button).
The absorption registered is shown according to the following diagram:
Level
channel CH1 waiting to be saved;
CH1 channel memory full;
channel CH2 waiting to be saved;
CH2 channel memory full;
channel CH3 waiting to be saved;
CH3 channel memory full;
CH1 channel waiting to be cancelled;
cancelling of channel CH1 in progress;
CH2 channel waiting to be cancelled;
cancelling of channel CH2 in progress;
CH3 channel waiting to be cancelled;
cancelling of channel CH3 in progress;
factory reset procedure waiting for confirmation;
waiting for total cancellation of the radio channels;
DL7
(Off)
(Green)
(Green)
(Green)
(Yellow)
(Yellow)
(Yellow)
(Red)
(Red)
25
DL8
(Off)
(Off)
(Green)
(Yellow)
(Green)
(Yellow)
(Red)
(Yellow)
(Red)