Installing The Cutter Guard; Mounting The Cutter Guard; 8-Tooth Eddy Blade (Ms-30 U, Ms-30 C) - Dolmar LT-30 Manual De Empleo Y De Seguridad

Installing the cutter guard

Important: Safety regulations and your own safety make
it imperative to use the right cutter guard with a given
cutting tool! Use only the combinations shown here, and
when switching to a different cutting tool always change
the cutter guard as well!
Tool/guard combinations for the MS-30 U and MS-30 C
Cutting tool
4-tooth star blade part no. 372 224 140
Outside diameter: 8" (200 mm), arbour: 4/5" (20 mm)
8-tooth eddy blade part no. 380 224 180
Outside diameter: 8" (200 mm), arbour: 4/5" (20 mm)
2-line trimmer head part no. 369 224 201
Cutting range: ø15 " (380 mm) / Use only .080" (2.0 mm) replacement cutting line!
15 m part no. 369 224 060
120 m part no. 369 224 062
3 2
A
Mounting position A
Tool/guard combination for the LT-30
Cutting tool
2-line trimmer head part no. 369 224 101
Cutting range: ø 18" (450 mm ) / Use only .080" (2.0 mm) replacement cutting line!
15 m part no. 369 224 060
120 m part no. 369 224 062
2
1
B
10
STOP
2
1
Mounting position B
Warning: Use only the cutting tools shown here! It is not
permitted to use other cutting tools as this can increase
danger of accidents and cause damage to the equipment!
Cutter guard
Part no. 010 341 202
Part no. 010 341 202
Part no. 010 341 202
* Line cutter
Install part no. 957 341 010!
The position of the mounting plate (A/1) will depend on the type
of cutting tool in use (trimmer head or metal blade).
The position of the mounting plate determines whether the
guard will be positioned higher or lower.
When using a trimmer (line) head apply the mounting position
as shown in fig. A. Always install the line cutter (A/3).
1
The mounting position as shown in fig. B is required for use with
the following tools:
• 4-tooth star blade
• 8-tooth eddy blade
- For installation place the protective hood onto the holder on
the angular gear, secure the protective hood with the
mounting plate, all depending on the tool you have chosen
(A or B), and tighten the fastening screws (A/2) with the
offset screwdriver (maintenance tool).
Cutter guard
Part no. 369 341 100
- Push the guard (B/1) onto the shaft until the holes of the
mounting plate (B/2) are flush with the holes on the guard.
- Insert the bolts (B/3) and tighten.
3
*