Putting Into Operation; Handle Installation, Ms-30 U; Handle Installation, Ms-30 C; Handle Installation, Lt-30 - Dolmar LT-30 Manual De Empleo Y De Seguridad

PUTTING INTO OPERATION

CAUTION: When working on the brushcutter always be absolutely certain to switch off the engine, pull the spark plug
cap and wear protective gloves!
IMPORTANT: Do not start the brushcutter until fully assembled and inspected!
Installing the handle, MS-30 U
A
- The bolts (A/3) are found in the enclosed pack.
- Position the handle (A/1) in the handle mounting (A/4) as
shown in the figure. The bend in the handle should be about
0.4" (1 cm) outside the mounting towards the rubber grip.
- Place the handle retainer plate (A/2) over the handle and
mounting and bolt it on loosely, screwing the bolts in evenly.
Installing the handle, MS-30 C
9
C
10
- Take the bolts and nuts (C/7, 8) and grip bracket (C/10)
from the enclosed pack.
- Place the handle (C/9) in the middle of the profile section
on the shaft tube.
- Attach the handle retainer plate (C/10) with bolts (C/7) and
nuts (C/8). Set the spacing between the two handles to
suit you and then tighten the bolts (C/7).
STOP
1 2 3
1 cm
4
7
8
5
6
B
6
- Push the handle about 10 to 20° forward and tighten the
bolts (B/3).
- Attach the bowden cable (B/5) to the shaft tube using the
cable ties (B/6) found in the enclosed pack.
NOTE:
The handle must be tilted to accommodate the operator, so
the exact angle will depend on the operator's body size. For
easiest operation the elbows should be slightly bent, with the
wrists straight.
Installing the handle, LT-30
13
14
D
- Take the bolts and nuts (D/11, 12) and grip bracket (D/14)
from the enclosed pack.
- Place the handle (D/13) in the middle of the profile section
on the shaft tube.
- Attach the handle retainer plate (D/14) with bolts (D/11)
and nuts (D/12). Set the spacing between the two handles
to suit you and then tighten the bolts (D/11).
3
11
12
9